Wulf's Webden

The Webden on WordPress

Supporting the Washing Up

| 0 comments

We’re still between dishwashers (ie. we haven’t replaced the one that broke a couple of months ago). I think we probably will get a replacement but, meanwhile, it has been back to washing up by hand. One of the limitations is draining space. We’ve got an extension board but it doesn’t sit high enough to let the water run back into the sink rather than on to the worktop. However, that probably shouldn’t be a problem for someone with a 3D printer…

This evening I’ve printed off a couple of supports that sit under the back of the board and lift it several centimetres higher. In turn that should give enough of an angle for the water to drain as we want. I’m looking forward to testing it after breakfast tomorrow and finding out if I’ve probably solved the problem or need to chalk this edition up as a prototype.

Leave a Reply

Required fields are marked *.


This site uses Akismet to reduce spam. Learn how your comment data is processed.